Build Volume: 6″ x 6″ x 6″ / 150mm x 150mm x 150mm / 216 cubic inches

Print Resolution: 100 Microns

Print Speed: 80mm/sec max recommended

Filament: 1.75mm PLA (sample included)

Extruder: Alu Extruder (direct drive) with 1.75mm Ubis Hot End with 0.4mm nozzle

Auto Leveling: Auto-Leveling Probe works with software to calibrate Z axis height (see video)

Print Bed: Not heated

Construction: Powder coated steel and aluminum body with 8mm and 12mm diameter linear shaft

Belt: GT2

Pulleys: 20 tooth, dual flange GT2 aluminum

Electronics: Printrbot Rev F Printrboard with micro-USB connection (cable included) and micro SD card slot for untethered printing

Software: Printrbot does not provide software, but recommends Cura and/or Repetier.  Both are available for free download.

Power Requirements: 12V (6 amp) laptop power supply (included)

Motors: NEMA 17 stepper

Overall Footprint*: 18″ x 17″ x 13″ (L x W x H)